COMPUR Monitors Gas detector Statox 501 PID

Brand:COMPUR Monitors
Model:Statox 501 PID
If you want to learn about the product, please contact us.
Please provide the brand, model, and quantity for inquiry.

Category:

Description

Statox 501 PID – VOC measurement in ppm range

PID technology is used to detect substances that cannot be detected with other methods. These include organic solvents and fuels, also known as VOCs (VOC = volatile organic carbons).

The to be measured gas molecule are split into charged particles by a very high-energy UV light beam within the PID detector (known as ionization) which are discharged on the plates of the capacitor. The resulting discharge current is proportional to the number of molecules and thus to the concentration.

The Statox 501 PID works with a 10.6 eV lamp and thus makes all substances measurable that can be ionized with 10.6 eV or less.

PID gas detectors are calibrated with isobutene. Since other substances are displayed with different sensitivities based on this gas, the corresponding calibration factors must be taken from a response-table in order to be able to display the concentration correctly. Our Statox 501 PID can be calibrated at the factory according to your requirements, so that it is ready for use immediately after delivery.

Similar to the voltage signal of a catalytic sensors, the Statox 501 PID delivers a linear output signal that is evaluated and displayed by our Statox 503 control module. A 4-20 mA analog output and the three powerful relays of the control module forward the measured value and, if necessary, alarm signals to a process control system or other peripheral devices.

Detectable Gases: All Substances of which the potential of ionisation is smaller than 10,6 eV
Measuring programs: 0 – 10 / 100 / 1000 ppm or 0 – 10000 ppm
Measuring principle: Photo-Ionisation
Response time: For Isobutene: t90 < 30 s
Operating temperature: -30 to +60°C
Humidity: 0 – 95 % r. H., non condensing
Pressure: 700 – 1300 hPa
Power supply: 4,6 to  5,6 VDC
Current: app. 50 mA, initial current max. 150 mA for 0,3 s
Wiring: 3- Wire
Operation: Statox 503 Control Module
Weight: ca. 1,0 kg
Dimensions (HxWxD): 160 x 130 x 60 mm
Material: Cast aluminum, Stainless steel
Ingress protection: min. IP54
Approval: II2G Ex e[ib]mb IIC T4 Gb

 

 

 

Buyer Notice
1. About the product
Due to market fluctuations, exchange rate changes, and other factors, product prices and product attributes are for reference only; The specific product requirements are subject to customer requirements, and the price is based on the communicated quotation. All product prices on this website are not considered transaction prices and are for reference only!
2. About Trademark Copyright
All company names, trademarks, logos, product images, product descriptions, product brand names, and trademark copyrights related to this website belong to the corresponding brands; This website is only designed for the convenience of product identification.
Please carefully read the buyer’s instructions to avoid unnecessary disputes.

Reviews

There are no reviews yet.

Be the first to review “COMPUR Monitors Gas detector Statox 501 PID”