Eagle Signal Electronic – reset timer CX202A6

Description

The CX200 is a microprocessor based timer/counter housed in a standard 15 terminal CYCL-FLEX plug-in case. Time or count
operation, time range, and standard or reverse start operation is selected by 7 miniature rocker switches located inside the unit housing.
Time or count setpoints are entered into the unit using a sealed membrane keypad on the front of the unit. Each digit in the setpoint is
individually increased or decreased by pressing the appropriate keypad switch. Time or count setpoint and progress is displayed on the front of
the unit by a 4 1/2 digit liquid crystal display with .5 inch digits. Time or count subtracts from the setpoint and the output changes state at zero.
Operational mode annunicators also appear in the display area on the front of the unit. The mode annunciator flashes when the unit is timing
or counting.
■ Five time ranges from 19.999 sec. to 199 hrs.: 59 min.
■ Two count rates – accept and display counts from 1 to 19999
■ Two relay outputs – socket mounted for easy replacement
■ Two form C instantaneous contacts and two form C programmed
contacts
■ N.O. solid state MOSFET, delayed action switch rated at 1 ampere
continuous load current, 0-264 VAC 50/60 Hz or DC
■ Ideal output for switching low level signals and high voltage loads
due to MOSFET output’s ON resistance of 0.5 ohm and very low
OFF leakage
■ Programmed outputs operate in one of four load sequences; OOX,
OXO, OOX with pulse output, and OOX pulse output with repeat
cycle operation
■ Standard start is defined as ON delay reset timer or counter
■ For standard start units, timer/counter resets on power failure
■ Reverse start or OFF delay units will not reset on power failure and
will continue cycle when power is restored
■ Non-volatile memory data retention

Buyer Notice

1. About the product

Due to market fluctuations, exchange rate changes, and other factors, product prices and product attributes are for reference only; The specific product requirements are subject to customer requirements, and the prices are subject to communication and quotation. All product prices on this website are not considered transaction prices and are for reference only!

2. Regarding trademark copyright

All company names, trademarks, logos, product images, product descriptions, product brand names, etc. related to this website, and all intellectual property rights such as trademark copyright belong to the corresponding brand; This website is only for the convenience of product identification.
Please carefully read the buyer’s instructions to avoid unnecessary disputes.